V2000-c Rfid Access Control User Manual [top]

The connector is a dry contact relay for the lock. You can set its normal state using the J1 jumper.

Before installation, ensure your environment meets the following requirements: DC 12V ±10% User Capacity: 1,000 to 2,500 users (model dependent) Card Reading Distance: 3–6 cm Card Type: ID (EM) card or IC (Mifare) card Output Interface: Wiegand 26 (for external readers) Lock Output Load: Max 3A 2. Installation and Wiring V2000-c Rfid Access Control User Manual

The delay time determines how long the lock remains open after a valid entry. Enter Programming Mode. Press 4 + [00–99 Seconds] + # . Note: 00 sets the relay to toggle mode (latched). 6. Troubleshooting The connector is a dry contact relay for the lock

If you wired a reed switch to terminal 7 (SEN): Installation and Wiring The delay time determines how

: Wait 10 minutes for the automatic security lockout period to expire, or power cycle the device to reset the buffer. If you need help with a specific configuration, tell me:

To enter programming mode, you must use the . The default master code is usually 990101 or 123456 . Enter/Exit Programming Mode Press * + [Master Code] + # . (The LED will turn red/flash). Press * to exit programming mode at any time. Change the Master Code